Skip to main content

How do I connect the Ignite Smart Sensor to my Thermostat?

This article takes you through how to connect (pair) an Ignite Smart Sensor to your Ignite Wireless system. This should only need doing once.

J
Written by James Hunter

Put the receiver into pairing mode.

Ignite Wireless

  1. Short press the pairing (middle) button on the Relay Module, this will make all three lights flash green.

  2. Then press the CH button, The CH button will now flash green.

Smart Sensor

With the receiver in pairing mode and ensuring the Inspire leaf logo is at the top, press and hold down button for 5 seconds.

All 5 LED's will slowly flash to indicate unit is in pairing mode.

Upon successful pairing, the centre LED on the Smart Sensor will rapidly flash.

If pairing fails, the two outside LED's will rapidly flash. Please try the pairing procedure again.

Did this answer your question?