Skip to main content

How do I connect the Ignite Smart Sensor to my Thermostat?

This article takes you through how to connect (pair) an Ignite Smart Sensor to your Ignite Wireless system. This should only need doing once.

J
Written by James Hunter

Put the receiver into pairing mode.

Ignite Wireless

  1. Long press BOTH buttons on the Receiver until '1 and WiFi' lights flash slowly.

  2. Using the LEFT button, cycle through the menu until 'CH' flashes.

  3. Press the RIGHT button, 'CH' will rapidly flash

Ignite Wireless (4 channel)

  1. Long press BOTH buttons on the Receiver until '1 and WiFi' lights flash slowly.

  2. Using the LEFT button, cycle through the menu until the required heating zone number flashes (1-4).

  3. Press the RIGHT button, this heating zone number will now rapidly flash.

Smart Sensor

With the receiver in pairing mode and ensuring the Inspire leaf logo is at the top, press and hold down button for 5 seconds.

All 5 LED's will slowly flash to indicate unit is in pairing mode.

Upon successful pairing, the centre LED on the Smart Sensor will rapidly flash.

If pairing fails, the two outside LED's will rapidly flash. Please try the pairing procedure again.

Did this answer your question?